Ten Basic Tips On DIY Roll Roofing Installation

Ten Basic Tips On DIY Roll Roofing Installation

Ten Basic Tips On DIY Roll Roofing Installation

It’s true to say that roll roofing serves an excellent way to finish a porch or a shed roof, especially if it has a slight slope. However, this type of roofing can become a wonderful method of covering a completely flat roof as well. Roll roofing is manufactured in wide long rolls which can be easily cut if necessary and further nailed where it’s needed. Generally speaking roll roofing installation is surprisingly simple and quickly if correctly done.

If you’re going to cover your roof with roll roofing for the first time remember that it’s highly recommended to complete installation when it’s minimum 50 degrees, otherwise the material can easily crack. Besides, due to the high temperature it will be much easier to work with the roll roofing easy to work with. It’s also advised to leave the material on the roof for several hours to get warm.

During the time while the material is getting warmer you can install a drip edge around the whole perimeter of the roof. In this way the water won’t work underneath the edge of the used roofing. Usually, this type of roofing is manufactured from plastic and has a special drip edge that is designed to protect the roof and provide it with a finished edge.

So, let’s get to ten tips on proper Roll Roofing Installation.

1. First of all, find some time and effort to clean your roof before starting installing new roofing.

2. Just like with any other roofing task, it’s necessary to pay special attention to the possible valleys. They should be properly covered and evened with the surface of the roof. You’re recommended to apply a roll of 18" wide roofing. It will do to cover the necessary length of the valley. The roll has to be attached to the valley with the help of the roofing nails which were prepared beforehand. Leave the distance of about six inches between the nails and approximately 3/4" from the edge.

3. The third tip tells you that the leaks are obvious to appear near valleys or on the edges of the roof. This fact should be considered as well while installing roll roofing. So, these areas are worth taking care of in order to prevent soon repairing of your roof again. In this way the chance of leaks will be diminished to zero and you’re going to save much money on repairs. Don’t be afraid of rainstorms any longer!

4. The next step for you is to locate a roll of 36" roofing just over the 18" roofing and attach it with nails as well.

5. After the valleys are all covered, use the other pieces of the roll roofing for them to be parallel to the roofing edge. You can use a piece of chalk for drawing a line in order to install the roofing correctly. It’s highly recommended to overlap the rolls by no less than three inches.

6. Always attach the rolls with nails on the side that is furthest from the roof’s edge. Leave about three inches between the nails.

7. The next piece of roll roofing should be applied in such a way for the overlap to cover the nail heads. You can use specially designed roofing cement that proves to be very effective in getting the two pieces of roofing together.

8. Dealing with a roof valley, cut the roll roofing for it to end 1/2" from the valley’s center.

9. In order to secure the roll’s edges roofing cement can be used.

10. A 12" roll of roofing can be further used with the roofing cement for it to run over the valley seam. It will also perfectly secure and cover the edges of the roof.

Roll Roofing Applying

Roll roofing is really an excellent material to be used in small projects, however it’s not recommended to use it with the purpose of covering the roof of a home. If you are looking for an ideal material for this goal, it’s advised to use a traditional one. It can be asphalt shingles, for instance, that proves to be very effective in preventing leaks.


Leave a Reply